If you’ve recently purchased the HP Deskjet 4155 printer, you might be wondering how to go about setting it up. The good news is that the process is relatively straightforward and can be done within a matter of minutes. In this article, we’ll provide you with a step-by-step guide on unboxing and setting up your HP Deskjet 4155 printer.

Unboxing Your Printer

The first step is to unbox your printer. Inside the box, you should find the following items:

– HP Deskjet 4155 printer
– Power cord
– Setup guide
– Ink cartridges
– USB cable (optional)

Once you’ve located these items, you can begin the setup process.

Setting Up Your Printer

1. Connect the Power Cord

The first step is to connect the power cord to the back of the printer and plug it into an electrical outlet. Make sure the printer is turned off before you do this.

2. Install the Ink Cartridges

Next, you’ll need to install the ink cartridges that came with your printer. To do this, locate the ink cartridge access door on the front of the printer. Lift it up and wait for the cartridge carriage to move to the center. Then, remove the plastic tape from the cartridges and insert them into the corresponding slots. Close the access door once you’re done.

3. Turn on the Printer

After you’ve installed the ink cartridges, it’s time to turn on the printer. Press the power button at the top of the control panel, and the printer should start up.

4. Load Paper

Once the printer is on, load some paper into the input tray. You can do this by pulling out the tray and adjusting the paper guides to fit the size of the paper you’re using. Then, push the tray back into the printer.

5. Connect to Wi-Fi

If you want to connect your printer to your Wi-Fi network, press the Wi-Fi button on the control panel. This will bring up a menu where you can select your network and enter the password. Make sure you have the correct password before attempting to connect the printer to the network.

6. Install the Software

Finally, you’ll need to install the software that came with your printer. You can do this by inserting the setup CD into your computer and following the on-screen instructions. Alternatively, you can download the software from the HP website.

Conclusion

Setting up your HP Deskjet 4155 printer is a simple process that can be done within a matter of minutes. By following the steps outlined in this guide, you’ll be up and running in no time. If you encounter any issues during the setup process, refer to the user manual or contact HP support for assistance.